standard pressure
英 [ˈstændəd ˈpreʃə(r)]
美 [ˈstændərd ˈpreʃər]
网络 标准气压; 标准压力; 标准大气压; 標準壓力
英英释义
noun
- a unit of pressure: the pressure that will support a column of mercury 760 mm high at sea level and 0 degrees centigrade
双语例句
- This paper from the working principle of static expansion method, pointed out the exist problem of the original device, redesigned the major parts and put forward a new way to test the preceding standard pressure.
从静态膨胀法的工作原理出发，指出原膨胀法测压装置存在的问题，对一些主要部件进行重新设计，提出前级标准压力测定新方法。 - Dependence of flashover voltage on gas pressure has been measured in vacuum and in atmospheric air using 10/ 30-nanosecond pulse power. The scope of gas pressure is between 8 × 10-4 Pa and standard atmospheric pressure.
对纳秒脉冲（10/30ns）下真空绝缘闪络电压随气压的变化趋势进行了实验研究，探讨的气压范围介于8×10-4Pa至标准大气压之间。 - Establishes an empirical formula relating temperature to saturated humidity ratio under standard atmospheric pressure by means of polynomial regression. Analyzes the calculating error in common engineering temperature range, and the error is less than 2.1 percent.
利用多项式回归拟合了标准大气压下温度与饱和含湿量之间的经验公式，并进行误差分析，认为在工程常用温度范围内，计算误差小于2.1%。 - Shock tube can be used for standard dynamic pressure calibration equipment except micro-pressure transducers.
激波管可以作为标准动态压力标准装置（微压传感器除外）。 - We use the standard electronic sphygmomanometer to measure the blood pressure. The staff must participate in the training of standard blood pressure measurement methods prior to the survey.
测量血压用标准电子血压计，所有参加血压测量的工作人员必须在调查前进行标准血压测量方法的培训。 - The problems in present assessment of the pressure temperature coefficient were pointed out, the variation law of the pressure temperature coefficient was systemically analyzed, and the method in calculating standard pressure coefficient was also established.
提出了目前评价压强温度系数所存在的问题，较系统地分析了压强温度系数的变化规律，建立了参比压强温度系数的计算方法。 - Status and Discussion about Application of Pipe Flange Standard in Pressure Vessels
管法兰标准在压力容器行业中的应用现状及探讨 - The freezing point of pure water at standard atmospheric pressure is32 F ( 0 C).
在标准大气压力下，纯水的冰点是0℃。 - Up till now, in the defect assessment standard of pressure vessel, a semi-experience method, equivalent K ( stress intensity factor) conversion, usually used to deal with beried and surface three dimen-sional crack.
在压力容器缺陷评定标准中对埋藏和表面三维裂纹问题的处理，通常采用半经验的等应力强度因子（K）换算方法。 - With the comparable parameter, the equivalent leakage, the standard of pressure test of some gas lines at home and abroad has been analysised in this paper.
用各试压工况的当量漏气量这一可比参数，对国内、外几种煤气管道的试压标准做了分析。